LAMONA LAM1901 Uživatelský manuál stáhnout pdf (Strana 14)

It may happen that other remote

controlled appliances may block

the signal. To avoid it do not

operate the remote of the

appliance and the hob at the

same time.

Cooker hoods with the Hob²Hood

function

To find the full range of cooker hoods which

work with this function refer to our

consumer website.

CARE AND CLEANING

WARNING! Refer to Safety

chapters.

General information

• Clean the hob after each use.

• Always use cookware with clean bottom.

• Scratches or dark stains on the surface

have no effect on how the hob operates.

• Use a special cleaner applicable for the

surface of the hob.

• Use a special scraper for the glass.

Cleaning the hob

• Remove immediately: melted plastic,

plastic foil, sugar and food with sugar. If

not, the dirt can cause damage to the

hob. Take care to avoid burns. Put the

special scraper on the glass surface at

an acute angle and move the blade on

the surface.

• Remove when the hob is sufficiently

cool: limescale rings, water rings, fat

stains, shiny metallic discoloration. Clean

the hob with a moist cloth and non-

abrasive detergent. After cleaning, wipe

the hob dry with a soft cloth.

• Remove shiny metallic discoloration:

use a solution of water with vinegar and

clean the glass surface with a moist

cloth.

TROUBLESHOOTING

WARNING! Refer to Safety

chapters.

What to do if...

Problem Possible cause Remedy

You cannot activate or oper-

ate the hob.

The hob is not connected to

an electrical supply or it is

connected incorrectly.

Check if the hob is correctly

connected to the electrical

supply. Refer to the connec-

tion diagram.

The fuse is blown. Make sure that the fuse is the

cause of the malfunction. If

the fuse is blown again and

again, contact a qualified

electrician.

Activate the hob again and

set the heat setting in less

than 10 seconds.

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Komentáře k této Příručce

Žádné komentáře